COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE: EPIC/SCARLET
955-0020_V6.0, REV-J | 150
POWER/KEY LOCK SWITCH
Turn on: Press and hold the switch in the down position for two (2) seconds.
Turn off: Press and hold the switch in the down position for five (5) seconds. Or, press the switch down into
the down position and release to access the Shutdown menu.
Lock keys: Move the switch to the up position to prevent unintentional operation. “KEYS LOCKED” display
above the Primary Soft Menu Buttons when lock is enabled.
REDMOTE BASICS
This section describes the common REDMOTE operations.
DOCK THE REDMOTE
1. Position the REDMOTE V-Mount dock over the V-Mount on the BRAIN or rear module.
2. Slide the REDMOTE down until you hear a click, which indicates the REDMOTE is securely attached.
NOTE: Docking the REDMOTE automatically pairs the REDMOTE with the camera when the DSMC is turned on
and wireless settings are enabled.
UNDOCK THE REDMOTE
1. Press both Release buttons, located on the sides of the REDMOTE.
2. Slide the REDMOTE up to release from the V-Mount on the BRAIN or rear module.
3. Remove the REDMOTE.
TURN ON THE REDMOTE
When docked, the REDMOTE automatically turns on when the DSMC is turned on.
Slide and hold the Power/Key Lock switch in the down position for two (2) seconds, then release.
TURN OFF THE REDMOTE
When docked, the REDMOTE automatically turns off when the camera is turned off.
Slide and hold the Power/Key Lock switch in the down position for five (5) seconds, then release.
Slide and hold the Power/Key Lock switch in the down position momentarily, then release. Select the desired
option from the Shutdown menu and press Enter:
‒ Shutdown Cam + REDMOTE: Turn off both DSMC and the REDMOTE
‒ Shutdown REDMOTE: Turn off the REDMOTE only.
‒ Shutdown Camera: Turn off the DSMC only. Option not available when the REDMOTE is docked.
NOTE: For maximum battery life, remove power from the REDMOTE by pressing the Power/Lock Switch down
into the off position and release. Then use the menu to turn off the device. When turning off the REDMOTE using
the Power/Lock Switch, a slight power draw remains and continues to drain the battery.
RECORD START/STOP
Start Record: Press and release the REC button. The Power/Recording LED illuminates red and the Timecode
value on the LCD display changes to red text.
Stop Record: Press and release the REC button. When media recording processes are complete, the Power/
Recording LED turns off and the Timecode value on the LCD display changes back to white text.
To Next Page
Loading...
Need help?
General
