EasyManuals Logo

RED Epic User Manual

RED Epic
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #217 background imageLoading...
Page #217 background image
RED DSMC OPERATION GUIDE: EPIC/SCARLET
COPYRIGHT © 2015 RED.COM, INC 955-0020_V6.0, REV-J | 217
AL LEICA-M MOUNT LENSES
This section describes the appropriate method for attaching and detaching Leica-M
®
lenses. For more
information, refer to the original manufacturer’s instructions. This section also lists lenses supported by the
DSMC AL Leica-M Mount.
WARNING: ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.
ATTACH LEICA-M LENSES
1. Rotate the locking ring counter-clockwise to release the DSMC mount cap.
2. Remove the rear lens cap and the DSMC mount cap.
3. Align the mounting index (white dot) on the lens with the mounting index on the DSMC AL Leica-M mount.
4. Insert the lens into the DSMC AL Leica-M mount.
5. Rotate the locking ring clockwise to secure the lens in place.
DETACH LEICA-M LENSES
1. Rotate the locking ring counter-clockwise to release the Leica-M lens.
2. Remove the Leica-M lens from the DSMC AL Leica-M mount.
3. Replace the rear lens cap and DSMC mount cap when the lens is not in use.
DSMC AL LEICA-M MOUNT SUPPORTED LENSES
The DSMC AL Leica-M Mount is compatible with most Leica M-series lenses with focal lengths of 50mm and
greater, EXCEPT for the 50mm f2.0 Dual-Range Summicron. The 50mm f2.0 Dual-Range Summicron has a
protruding lug on the exterior of the lens body for mounting a supplementary finder. This lug interferes with
the locking ring on the DSMC AL Leica-M Mount. Most Leica lenses with focal lengths of less than 50mm will
encounter mechanical interference between the rear lens cell and the camera’s front panel.
EPIC DRAGON AND SCARLET DRAGON
If you are using an EPIC DRAGON or SCARLET DRAGON
®
camera, you do not need to install a new OLPF
frame. You can attach most Leica-M lenses without causing any interference with camera.
EPIC MYSTERIUM-X AND SCARLET MYSTERIUM-X
If you are using an EPIC MYSTERIUM-X
®
or SCARLET MYSTERIUM-X camera, you need to install a new OLPF
frame (included with the DSMC AL Leica-M Mount). Leica-M lenses are incompatible with older models of the
OLPF frame originally installed in the EPIC MYSTERIUM-X and SCARLET MYSTERIUM-X.
For more information, go to OLPF Frame Installation Instructions available at www.red.com/downloads.
WARNING: Attempting to mount Leica lenses of focal lengths of less than 50mm could result in damage to the
lens and/or the camera.

Table of Contents

Other manuals for RED Epic

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RED Epic and is the answer not in the manual?

RED Epic Specifications

General IconGeneral
SensorMysterium-X
Resolution5120 x 2700 (5K)
Lens MountPL Mount
Frame Rates1-120 fps
Dynamic Range13.5 stops
Recording FormatREDCODE RAW
MediaREDMAG (SSD)
Weight5 lbs (2.3 kg) body only
Sensor Size27.7 mm x 14.6 mm
Operating Temperature32°F to 104°F (0°C to 40°C)

Related product manuals