STAND ALONE PROGRAMMABLE SAFETY CONTROLLER
8541403 • 19/07/2021 • Rev.1 13
CHECKLIST AFTER INSTALLATION
The MZERO unit is able to detect in real time the faults.
Anyway to have the system perfect operation perform the following checks at start up and at least
every one year:
1. Operate a complete system TEST (see "TESTING the system")
2. Verify that all the cables are correctly inserted and the terminal blocks well
screwed.
3. Verify that all the leds (indicators) light on correctly.
4. Verify the positioning of all the sensors connected to MZERO.
5. Verify the correct fixing of MZERO to the Omega rail.
6. Verify that all the external indicators (lamps) work properly.
➔ After installation, maintenance and after any eventual configuration change perform a
System TEST as described in the paragraph "TESTING the system".
To Next Page
Loading...
