Reer MZERO - Standard Tool Bar

STAND ALONE PROGRAMMABLE SAFETY CONTROLLER
8541403 • 19/07/2021 • Rev.1 25
English
Standard tool bar
The standard tool bar is shown in Figure 14. The meanings of the icons are listed below:
Figure 14
1
CREATE A NEW PROJECT
2
CHANGE USER PARAMETERS (name, company, etc)
3
SAVE THE ACTUAL PROJECT
4
LOAD AN EXISTING PROJECT (FROM THE PC)
5
PRINT THE PROJECT SCHEMATIC
6
PRINT PREVIEW
7
PRINTING AREA
8
SNAP TO GRID
9
RESOURCES ALLOCATION
10
PRINT THE PROJECT REPORT
11
UNDO (CANCEL THE LAST COMMAND)
12
REDO (RESTORE THE LAST CANCELLATION)
13
VALIDATE THE PROJECT
14
CONNECT TO MZERO
15
SEND PROJECT TO MZERO
16
DISCONNECT FROM MZERO
17
DOWNLOAD AN EXISTING PROJECT (FROM MZERO)
18
MONITOR (Real time I/O status - graphic)
19
MONITOR (Real time I/O status - textual)
20
DOWNLOAD LOG FILE
21
SHOW SYSTEM CONFIGURATION
22
DOWNLOAD ERRORS LOG
23
DELETE ERRORS LOG
24
SCHEMATIC SIMULATION
25
GRAPHIC SIMULATION
26
CHANGE PASSWORD
27
HELP ON-LINE
28
PASSWORD RECOVERY (only with the unlock file, see Level 2 password)