MZERO SAFETY DESIGNER SOFTWARE
The "MZERO SAFETY DESIGNER" (MZD) application software can be used to configure a logic
diagram of the connections between MZERO and the components of the system being developed.
The MZERO will thus monitor and control the connected safety components.
The MZD uses a versatile graphic interface to establish the connections between the various
components, as described below.
Installing the software
PC HARDWARE requirements
• RAM: 2 MB (minimum to run 7 with Service Pack 1 + Framework 4.8)
• Hard disk: ≥ 500 MB free space
• USB port: 2.0 or greater
• Internet connection for installation program download
PC SOFTWARE requirements
• Windows 7 with Service Pack 1 installed (or higher OS)
• Microsoft Framework 4.8 must be installed on the PC
Installation of MZD software
• Run the “SetupDesigner.exe” file downloading the last available version from the
Download section of the ReeR website:
https://www.reersafety.com/it/en/download/configuration-software.
• Follow the indications of the setup.
➔ When the installation procedure is complete a window is displayed asking you to close the
setup program.
To Next Page
Loading...
