Renkforce RF500 Maker Construction Kit - Page 83

83
AttachmentofthecablestothemainPCB
Place and fasten the cables at the main PCB.
Takelongcableties(142mm)forthethickercablestrandsandthe
shortcableties(99mm)forthethinnercablestrands.
Assemblyoftheconnectionplugforthemainsunit
1x mains unit
1xcable09approx.85mm(2lines;1xred;1xblack)
1xconnectionplugfromthemainPCB(green)
Connect the two lines of cable 09 to the connection plug of the main
PCB.
The black line goes into the terminal at the far right, the red one into
the terminal to the left of it.