Respironics SmartMonitor2 - Dealer Preparation for Home Setup; Electromagnetic interference (EMI)

Setting Alarm and Recording Limits
25
Menu Option LCD Display Description of Option or Instructions Menu Path
When the auxiliary equipment channels are turned on and the auxiliary equipment is not connected
to the SmartMonitor 2, a flat line will be recorded and reported.
The auxiliary channels enable you to interface other signals to SmartMonitor 2. Options for each of
these channels are best defined with the System Software. External auxiliary devices can be interfaced
to provide Sp02, Pulse, EtCO2, pH, or any analog signal in the range of –1.25 to +1.25 volt.
The Synergy-E software will allow you to customize the channel label, voltage range, and value scale.
For instance an Oximeter may have a range of 0-1 volt and a scale of 0-100%. Refer to the Synergy-E
Operators Manual for more information.
Date DATE To enter the date:
 Press Enter to begin.
 Press t or u until the number required is
displayed.
 Press Enter to select.
 Once you have entered the date the display
will stop flashing.
 Press t to proceed to the next menu or u
to move to the previous menu.
All Menus
System Menu
Time TIME To enter the Time:
 Press Enter to begin.
 Press t or u until the number required is
displayed.
 Press Enter to select.
 Once you have entered the time the display
will stop flashing.
 Press t to proceed to the next menu or u
to move to the previous menu.
All Menus
System Menu
Rate Display RATE DISPLAY Controls whether the patient’s respiration and
heart rate will be displayed on the bottom panel
display during monitoring.
Values:
ON, OFF
Standard Value: OFF
All Menus
System Menu
Phone
Number for
Computer
COMPUTER
PHONE #
Enter the phone number of the modem on the
Computer end of the download.
You may enter *70 first then the phone
number to disable Call Waiting if necessary.
 Press Enter to begin.
 Press t or u until the number required is
displayed.
 Press Enter to select.
 Once you have entered the phone number
press t or u until the ^ appears. Then
press Enter. Any other information following
after the ^ will be cleared.
 Press t to proceed to the next menu or u
to move to the previous menu.
All Menus
System Menu