Ricoh 5510L - Page 210

DEDICATED TRANSMISSION PARAMETERS 14 June, 2002
5-88
Switch 04
No. FUNCTION COMMENTS
0-1 mm-inch conversion before tx
Bit 1 Bit 0 Setting
0 0 mm-inch
conversion
available
0 1 mm only
1 0 Not used
1 1 Disabled
The machine uses inch-based
resolutions for scanning. If ”mm only”
is selected, the printed copy may be
slightly distorted at the other end if that
machine uses inch-based resolutions.
2-3 DIS/NSF detection method
Bit 3 Bit 2 Setting
0 0 First DIS or NSF
0 1 Second DIS or NSF
1 0 First DIS or NSF
1 1 Setting disabled
(0, 1): Use this setting if echoes on the
line are interfering with the set-up
protocol at the start of transmission.
The machine will then wait for the
second DIS or NSF before sending
DCS or NSS.
4 V.8 protocol
0: Disabled
1: Enabled
If transmissions to a specific
destination always end at a low
modem rate (14,400 bps or lower),
disable V.8 protocol so that V.34
protocol will not be used.
0: V.34 communication will not be
possible.
5 Compression modes available in transmit
mode
0: MH only
1: All available compression modes
This bit determines the capabilities that
are informed to the other terminal
during transmission.
6-7 ECM during transmission
Bit 7 Bit 6 Setting
0 0 Disabled
0 1 Enabled
1 0 Disabled
1 1 Setting disabled
For example, if ECM is switched on
but is not wanted when sending to a
particular terminal, use the (0, 0)
setting.
Switches 05 to 08 - Not used (do not change the settings)
Switch 09 (Optional ISDN G4 unit required)
No. FUNCTION COMMENTS
0
to
3
Layer 3 protocol
Bits 3 2 1 0 Setting
0 0 0 0 ISO 8208
0 0 0 1 T.70 NULL
1 1 1 1 Disabled
Other settings: Not used
When disabled, the setting of G4
parameter switch 6 (bit 0) setting is used.
4-7 Not used Do not change the settings.