Ricoh 5510L - Page 211

14 June, 2002 DEDICATED TRANSMISSION PARAMETERS
5-89
Service
Tables
Switch 10 (Optional ISDN G4 unit required)
No. FUNCTION COMMENTS
0-1 Attachment of the Higher Layer
Capabilities
Bit 1 Bit 0 Setting
0 0 Attached
0 1 Not attached
1 0 Not used
1 1 Same as G4ISW 13
bit 4
This bit determines whether Higher Layer
Capabilities are informed in the [SETUP]
signal or not.
2-3 ISDN G3 information transfer
capability for transmission
Bit 3 Bit 2 Setting
0 0 Speech
0 1 3.1KHz Audio
1 0 Not used
1 1 Same as G4ISW 14
bit 0
This determines the information transfer
capability informed in the [SETUP]
message. Set this bit to “Speech” if the
ISDN does not support 3.1 kHz audio.
Note: The setting of this switch has a
higher priority than the G4 internal switch
13 bit 1 setting (Information transfer
capability shift down on/off): Shift down
procedure is disabled if this switch is set to
either “Speech” or “3.1 kHz audio.”
4-7 Not used Do not change the settings.