Simplifying the Operation
132
7
Using a Program
Note
❒ Using the program causes the pre-
vious settings to be cleared.
❒ If you have no programmed desti-
nations or scan settings as programs,
select the program number, and
then enter the fax number of the
destination and select the scan set-
tings you require.
A Make sure that the machine is in
facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not shown,
press the {Facsimile} key.
B Place the original.
C Press the {Program} key.
D Confirm that [Recall] is selected,
and press the registered program
number.
The standby display appears.
Then, the programmed fax number
is shown. Transmission Mode is
selected.
E Press the {Start} key.
The fax number and specified time
are shown on the display, and the
machine starts to scan the original.
Transmission starts at the specified
time.
To Next Page
Loading...
