Administrator Setting
172
9
Printing the User Parameter List
Print this list to see the current User
Parameter settings. However, only
items of importance or often-used
items are included in the list.
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Administrator Tools].
D Press [Print List] next to “Parameter
Setting”.
E Press the {Start} key.
Note
❒ To cancel printing a list before press-
ing the {Start} key, press [Cancel]
or the {Clear/Stop} key. The dis-
play returns to that of step
D
.
❒ To cancel printing a list after press-
ing the {Start} key, press [Stop
Printing]. The display returns to
that of step
D
.
F Press the {User Tools/Counter} key.
The standby display appears.
Special Senders to Treat
Differently
By programming particular senders
in advance, you can set the following
function for each sender:
•Authorized RX
•Forwarding
• Reception File Print Qty
•Print 2 Sided
•Memory Lock
•Paper Tray
Use the Own Name or Own Fax Number
to program your senders. If the sender
has a machine of the same manufacturer,
program an Own Name that has al-
ready been programmed as a sender.
If the machine is not of the same man-
ufacturer, use Own Fax Number. You
can apply the same settings to all pro-
grammed numbers. You can then cus-
tomize the settings for individual
numbers as necessary using the Spe-
cial Sender Registration function.
The following items can be programmed.
• Special Senders (Up to 30. A maxi-
mum of 20 characters for each name
when using G3.)
• Full/Partial agreement
When you program own names
and facsimile names for multiple
destinations, you can program a
common sequence of characters to
identify destinations using Partial
agreement.
To Next Page
Loading...
