Using Administrator Settings
161
9
Note
❒ Each time you press [mm] or
[inch], the units switch between
“mm” and “inch”. If you enter a
length and change the units by
pressing [mm] or [inch], the
length is converted automati-
cally according to the unit (frac-
tions are rounded off). For example,
when you enter {2}, {2}, and
{0} in millimeters and change to
“inch”, the length “8.7 inch” is
shown on the display. If you
press [mm] or [inch] again, “221
mm” is displayed.
❒ If you make a mistake, press [Clear]
or the {Clear/Stop} key, and then
try again.
❒ To cancel a scan size, press [Can-
cel].
G Select a vertical size, and then press
[OK].
Note
❒ The displayed vertical size dif-
fers depending on the selected
unit. When [mm] is selected, [Au-
to Detect], [210 mm (A4)], [257 mm
(B4 JIS)], [297 mm (A3)], [216 mm
(8 1/2)], and [279 mm (11)] are
shown. When [inch] is selected,
[Auto Detect], [8.3 inch (A4)], [10.1
inch (B4 JIS)], [11.7 inch (A3)], [8.5
inch], and [11.0 inch] are shown.
❒ To cancel a scan size, press [Can-
cel].
H Press [Exit].
I Press the {User Tools/Counter} key.
The standby display appears.
Deleting a scan size
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Administrator Tools].
D Press [Program / Change / Delete Scan
Size].
E Press [Delete], and then select [Pro-
gram Size 1] or [Program Size 2].
F Press [Yes].
Note
❒ To cancel deleting, press [No]. The
display returns to that of step
E
.
G Press [Exit].
H Press the {User Tools/Counter} key.
The standby display appears.
To Next Page
Loading...
