Administrator Setting
190
9
Note
❒ You can change the display
to the fax destination, Inter-
net fax destination, and IP-
Fax destination using the
button on the right side of the
display.
❒ A reception station can also
be registered as a group des-
tination. In such a case, a
maximum of 500 parties in-
cluding End Receivers 1-5
can be specified in a group.
To register another End Receiv-
er, repeat from step A.
Programming a password
If you do not want to program a
password, proceed to step
K
.
A Press [Password].
B Enter a password, and then press
[OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key
before pressing [OK], and then
try again.
C Re-enter the password, and then
press [OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key
before pressing [OK], and then
try again.
❒ To change the password after
pressing [OK], press [Change]
and repeat steps B and C, or
press [Cancel] and repeat from
step A.
D Press [OK].
K Press [OK].
L Press [Exit].
M Press the {User Tools/Counter} key.
The standby display appears.
Deleting Transfer Boxes
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Administrator Tools].
To Next Page
Loading...
