Transmission Mode
16
1
Polling Reception Reserve
Report
This report is printed after Polling Re-
ception is set up.
Note
❒ You can turn this function on or off
with the User Parameters. See p.167
“User Parameters” (switch 03, bit
3).
❒ You can have a destination displayed
with the User Parameters. See p.167
“User Parameters” (switch 04, bit 4).
❒ You can display a sender name with
the User Parameters. See p.167 “Us-
er Parameters” (switch 04, bit 5).
Polling Reception Result
Report
This report is printed after each Polling
Reception is completed and shows its
result.
If E-mail TX Results is programmed
in a Quick Operation key, you can se-
lect whether a report e-mail is sent after
reception. See p.146 “Quick Operation
Key”.
Note
❒ You can also check the result of a
Polling Reception with the Journal.
See p.27 “Printing the Journal”.
❒ You can turn this function on or off
with the User Parameters. See p.167
“User Parameters” (switch 03, bit
4).
❒ To view the report without text dis-
ruption, select a font of even charac-
ter width in your e-mail application's
settings.
❒ You can display a destination with
the User Parameters. See p.167 “Us-
er Parameters” (switch 04, bit 4).
❒ You can display a sender name with
the User Parameters. See p.167 “Us-
er Parameters” (switch 04, bit 5).
To Next Page
Loading...
