On Hook Dial
57
4
On Hook Dial
The On Hook Dial function allows
you to dial while listening to the tone
from the internal speaker. You can
send a fax checking the connection.
Limitation
❒ This function is not available for
the optional extra G3 interface
unit, Internet Fax and IP-Fax.
Note
❒ This function is unavailable in some
countries.
❒ If an Immediate TX Result Report
(Immediate Transmission) is print-
ed, On Hook Dial transmission re-
sults are not mentioned on the report.
A Place the original, and then select
the scan settings you require.
Reference
p.15 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.34 “Scan Settings”, Facsimile
Reference <Basic Features>
B Press the {On Hook Dial} key.
You will hear a low tone from the
internal speaker.
Note
❒ If you want to cancel this oper-
ation, press the {On Hook Dial}
key again.
C Dial.
The machine immediately dials the
destination.
Note
❒ You can adjust the volume of
the on-hook sound by pressing
[Higher] or [Lower] in the upper
right-hand corner of the display.
The volume can also be prepro-
grammed in “Gen. Settings/ Ad-
just”. See p.91 “Adjusting the
Volume”, Facsimile Reference
<Basic Features> and p.145
“General Settings/Adjust-
ment”.
❒ If you make a mistake, press the
{On Hook Dial} or {Clear Modes}
key, and then return to step
B
.
D When the line is connected and you
hear a high-pitched tone, press
the {Start} key.
The transmission starts.
Note
❒ After transmission, the machine
returns to standby mode.
❒ If you want to cancel a transmis-
sion, press the {Clear/Stop} key,
and then remove the originals.
To Next Page
Loading...
