Transmission Mode
6
1
Note
❒ If a destination protection code
is set, the entry screen appears.
Enter the protection code for
destination using the number
keys, and then press [OK].
E Confirm the selected sender, and then
press [OK].
F Select [On] or [Off] for the Stamp
Sender Name.
Printing on the Receiver's Sheet
If you enable this function, the send-
er's name (user name) appears on
the receiver's sheet, lists, and report.
A Select [On] for the Stamp Send-
er Name function.
Confirming transmission results
by e-mail
If the sender's e-mail address is
registered you can specify whether
or not to send the transmission re-
sult by e-mail to the sender. If you
enable this function, the transmis-
sion result is sent to the registered
mail address.
Note
❒ If a user logs in with User ID,
the transmission result is sent
by e-mail to the logged-in user.
❒ You can confirm transmission
results by using both the E-mail
TX Results function, which
sends the results by e-mail, and
the Communication Result Re-
port printed by the machine.
You can set whether to use both
of these together in User Param-
eters. See p.167 “User Parame-
ters” (switch 10, bit 6).
A Select [Yes] or [No] for the E-
mail TX Results function.
To Next Page
Loading...
