Ricoh Aficio 3045 - Page 193

Using Administrator Settings
183
9
F Select a box to program.
When programming a new box,
press [*Not Programmed].
Note
❒ To change a box already programmed,
press it and proceed to step
I
.
G Press [Personal Box].
H Enter a box name, and then press
[OK].
Reference
“Entering Text”, General Set-
tings Guide
I Enter a SUB Code.
Note
❒ To change the SUB Code, press
[Clear] or the {Clear/Stop} key,
and then try again. To change a
Box name, press [Box Name], and
then repeat from step
H
.
J Specify the settings you require.
If you do not want to program a
password or receiver, proceed to
step
K
.
Programming a password
A Press [Password].
B Enter a password, and then press
[OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key
before pressing [OK], and then
try again.
C Re-enter the password, and then
press [OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key
before pressing [OK], and then
try again.
❒ To change the password after
pressing [OK], press [Change]
and repeat steps B and C, or
press [Cancel] and repeat from
step A.
D Press [OK].