Ricoh Aficio 3045 - Page 196

Administrator Setting
186
9
F Select the box to program.
When programming a new box,
press [*Not Programmed].
Note
❒ To change a box already pro-
grammed, press it, and then pro-
ceed to step
I
. If a password is
programmed, enter the pass-
word, press [OK], and then pro-
ceed to step
I
.
G Press [Information Box].
H Enter a box name, and then press
[OK].
Reference
“Entering Text”, General Set-
tings Guide
I Enter the SEP Code.
Note
❒ To change the SEP Code, press
[Clear] or the {Clear/Stop} key,
and then try again. To change
the box name, press [Box Name],
and then repeat the procedure
from step
H
.
J Press [Password].
Note
❒ If you do not want to program a
password, proceed to step
N
.
K Enter a password, and then press
[OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key be-
fore pressing [OK], and then try
again.
L Re-enter the password, and then
press [OK].
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key be-
fore pressing [OK], and then try
again.
❒ To change the password after
pressing [OK], press [Change]
and repeat steps
K
and
L
, or
press [Cancel] and repeat from
step
J
.
M Press [OK].
N Press [OK].