Transmission Mode
12
1
❒ Polling Transmission Clear Report
allows you to verify Polling Trans-
mission has taken place. See p.13
“Polling Transmission Clear Re-
port”.
❒ You can program one of the Quick
Operation keys with operations for
this function. Using this key allows
you to omit step B. See p.145 “Gen-
eral Settings/Adjustment”.
❒ The communication fee is charged
to the receiver.
A Place the original, and then select
the scan settings you require.
Reference
p.15 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.34 “Scan Settings”, Facsimile
Reference <Basic Features>
B Press [Transmission Mode].
C Press [Polling TX].
D Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that [Free Polling TX] is se-
lected.
Default ID Transmission
A Select [Default ID TX].
ID Override Transmission
A Select [ID Override Transmission].
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F].
Note
❒ A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key,
and then try again.
E Press [Only Once] or [Save] to delete
or save the file after transmission.
Note
❒ To delete the original immedi-
ately after transmission, select
[Only Once].
❒ To repeatedly send the original,
select [Save].
❒ To cancel Polling Transmission,
press [Cancel]. The display returns
to that of step
C
.
To Next Page
Loading...
