Other Transmission Features
54
4
❒ When using a Transfer Request
by e-mail, originals are sent at
A4 width. Originals larger than
A4 are reduced to A4 width. If
the receiver is in compliance
with the T.37 full mode, origi-
nals are sent at the width speci-
fied in the Address Book. See
p.61 “T.37 Full Mode”, Facsimile
Reference <Basic Features>.
Reference
p.15 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.34 “Scan Settings”, Facsimile
Reference <Basic Features>
B Specify a Transfer Station.
Note
❒ Enter directly or use a destination
list to specify the fax number, e-
mail address, or IP-Fax destina-
tion of the Transfer Station.
❒ If you make a mistake, press [Clear]
or the {Clear/Stop} key, and then
try again.
❒ When a Transfer Request is sent
by e-mail, e-mail options can be
set. See steps
B
and
C
on p.63
“Sending Internet Fax Docu-
ments”, Facsimile Reference <Ba-
sic Features>.
Reference
p.39 “Entering a Fax Number”,
Facsimile Reference <Basic Fea-
tures>
p.41 “Entering an E-mail Ad-
dress”, Facsimile Reference <Basic
Features>
p.43 “Entering an IP-Fax Desti-
nation”, Facsimile Reference <Ba-
sic Features>
p.45 “Using the Destination List
to Specify Single or Group Des-
tinations”, Facsimile Reference
<Basic Features>
C Press [Adv. Features].
D Press [Transfer Req.].
E Press [Receiving Statn].
F Specify a Receiving Station.
Note
❒ You cannot enter Receiving Station
numbers directly. The numbers
must be stored in destination
lists, Speed Dial, or Groups in
the Transfer Station(s). To spec-
ify a Receiving Station, use the
following procedure.
❒ To cancel the Transfer Request,
press [Cancel] twice. The display
returns to that of step
E
.
To Next Page
Loading...
