Manual Dial
93
1
Manual Dial
Pick up the optional handset or the handset of the external telephone and dial. When the line
is connected and you hear a high-pitched tone, press the
{
Start
}
key to send your fax docu-
ment. If, on the other hand, you hear a voice at the other end, continue conversation as normal.
Important
❒ The optional handset or an external telephone is required.
❒
This function is not available for the optional extra G3 interface unit, Internet Fax and IP-Fax.
A Place the original, and then select the scan settings you require.
B Pick up the handset.
You will hear a dial tone.
C Dial.
The machine immediately dials the destination.
If you make a mistake, replace the handset, and then try again from step
B
.
To select a destination from the Address Book, see “Using the Address Book
to Specify Destinations”.
D When the line is connected and you hear a high-pitched tone, press the
{Start} key to send your fax document.
If you hear a voice, tell the receiver that you want to send them a fax docu-
ment (ask them to switch to facsimile mode).
The transmission starts.
E Replace the handset.
If you want to cancel a transmission, press the
{
Clear/Stop
}
key, and then remove the originals.
After transmission, the standby display appears.
Note
❒
When the operation switch is off, even if the main power switch is on, you cannot
operate this machine using only the optional handset or the handset of the exter-
nal telephone. You must first press the operation switch to turn on the machine.
Reference
p.70 “Using the Address Book to Specify Destinations”
To Next Page
Loading...
Need help?
General
