Reception
162
3
Reception Modes
There are two ways you can set up the machine to handle incoming calls:
• Manual Reception (the optional handset or an external telephone required)
• Auto Reception
You can change the reception mode only if a standard G3 line is used.
You cannot change the reception mode when a line other than the standard G3
line (G3-2 or G3-3) is used.
Note
❒ The optional handset or an external telephone is required to use this machine
as a telephone.
Manual Reception
When a telephone call comes in, the machine rings. If the call is a fax document,
you must switch manually to facsimile mode.
A When the machine rings, pick up the optional handset or the handset of the
external telephone.
B If you hear beeps, press the {Start} key or the {Start Manual RX} key. (The
{Start} key is only available in facsimile mode when an original is not
placed.)
C Replace the optional handset or the handset of the external telephone. The
machine will start receiving.
Note
❒
When the operation switch is off, even if the main power switch is on, you cannot
operate this machine using only the optional handset or the handset of the exter-
nal telephone. You must first press the operation switch to turn on the machine.
Auto Reception
When a telephone call comes in, the machine automatically receives it as a fax
document. Use this setting on a dedicated fax line.
To Next Page
Loading...
Need help?
General
