Reception
184
3
Note
❒ You can turn this function on or off with the User Parameters (switch 10, bit 3)
in the Facsimile Features menu.
❒ When this function is used, the printing quality may not be as good as usual.
Reference
p.182 “Page Separation and Length Reduction”
“Facsimile Features”, General Settings Guide
TSI Print (Transmitting Subscriber Identification Print)
Usually the sender's Fax Header is printed on received documents. When you
receive an Internet Fax document, the e-mail address of the sender is printed. If
the sender has not programmed their Fax Header, you will not be able to iden-
tify them. However, if you turn this function on, the sender's Own Name or Own
Fax Number is printed instead so you can find out where the document came
from.
Note
❒ You can turn this function on or off in the User Parameters (switch 02, bit 3)
in the Facsimile Features menu.
Reference
“Facsimile Features”, General Settings Guide
If There Is No Paper of the Correct Size
If there is no paper in the machine that matches the size of a received document,
the machine will choose a paper size based on the paper available.
Note
❒ The document is split over two sheets of paper depending on the paper size.
❒ Paper placed in the bypass tray is not usually selected for printing a received
document. However, you can use this tray if you select the bypass tray as the
main paper tray using Reception with Specified Senders.
❒ Widths that this machine can receive are A4, B4 JIS, LT (8
1
/
2
"×11") and A3.
Any documents narrower than A4 or LT (8
1
/
2
"×11") are received at A4 or LT
(8
1
/
2
"×11") width. The length of documents depends on the document.
❒ The paper size used to print a received document may be different from the
size of the sent original.
Page reduction Disabled
Reduction in Sub-scan Direction Enabled
Page Separation Threshold 20 mm (0.79")
Width or Length Priority Width
To Next Page
Loading...
Need help?
General
