Sender Settings
115
2
G To confirm the transmission results by e-mail notification, select [Yes] for
the E-mail TX Results function.
If the sender's e-mail address is registered, you can send the transmission re-
sult to the registered e-mail address.
H Press [OK].
The display returns to that of step
C
.
The selected sender's name appears above [Sender Settings]. The sender name
is displayed in up to 14 characters, followed by an ellipsis (. . . ).
I Press [OK].
The standby display appears.
To check the settings, press [Transmission Mode].
J Specify the destination, and then press the {Start} key.
To Next Page
Loading...
