Other Transmission Features
120
2
D To use the Default ID function, check that [Default ID] is selected, and then
press [OK].
To cancel Confidential Transmission, press [Cancel]. The display returns to
that of step
C
.
E To use the Override ID function, select [ID Override], enter the Confidential
ID (4-digit number) using the number keys, and then press [OK].
“ID Override: ” and the entered Confidential ID are shown above the high-
lighted [Confidential TX].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
To cancel Confidential Transmission, press [Cancel]. The display returns to
that of step
C
.
F Press [OK].
The standby display appears.
To check the settings, press [Transmission Mode].
G Specify the destination, and then press the {Start} key.
Note
❒ It is recommended that you program the Confidential ID in this machine
beforehand.
❒ An ID can be any 4-digit number (except 0000).
❒ If the destination machine is not of the same manufacturer, you can use
Confidential Transmission with “SUB Code”.
❒ You can cancel the transmission setup for Confidential Transmission. See
“Before the Transmission Is Started”.
To Next Page
Loading...
