Other Transmission Features
124
2
G Press [Only Once] or [Save] to delete or save the file after transmission.
To delete the original immediately after transmission, select [Only Once].
To repeatedly send the original, select [Save].
To cancel Polling Transmission, press [Cancel]. The display returns to that of
step
C
.
H Press [OK].
“pppppppppp” appears.
The type of Polling Transmission is shown above the highlighted [Polling TX].
I Press [OK].
To check the settings, press [Transmission Mode].
J Press the {Start} key.
Note
❒ A Polling ID may be any four numbers (0 to 9) and characters (A to F), ex-
cept 0000 and FFFF.
❒ Free Polling and Default ID Transmission allow only one file to be stored
in memory.
❒ ID Override Polling Transmission allows a file to be stored in memory for
each ID. For the maximum number of files you can store in memory by
changing IDs, see “Maximum Values”.
❒ You can set whether a Polling Transmission file is deleted in User Param-
eters (switch 11, bit 7) in the Facsimile Features menu. To save a file for fre-
quent sending, set to “Standby (Save)”.
❒ Polling Transmission Clear Report allows you to verify Polling Transmis-
sion has taken place.
❒ You can program one of the Quick Operation keys with operations for this
function. Using this key allows you to omit step
B
.
❒ The communication fee is charged to the receiver.
❒ You can cancel the transmission setup for Polling Transmission. See “Be-
fore the Transmission Is Started”.
Reference
p.107 “Before the Transmission Is Started”
p.125 “Polling Transmission Clear Report”
p.230 “Information Boxes”
p.291 “Maximum Values”
“Facsimile Features”, General Settings Guide
To Next Page
Loading...
