Error Codes
SM 29 D418
Fax Option
Type 9001
D418
Code Meaning Suggested Cause/Action
0-55
FCE does not detect the
SG3-V34.
FCU firmware or board defective.
SG3-V34 firmware or board defective.
0-56
The stored message
data exceeds the
capacity of the mailbox in
the SG3-V34.
SG3-V34 firmware or board defective.
0-70
The communication
mode specified in CM/JM
was not available
(V.8 calling and called
terminal)
The other terminal did not have a compatible
communication mode (e.g., the other terminal
was a V.34 data modem and not a fax
modem.)
A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
0-74
The calling terminal fell
back to T.30 mode,
because it could not
detect ANSam after
sending CI.
The calling terminal could not detect ANSam
due to noise, etc.
ANSam was too short to detect.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
0-75
The called terminal fell
back to T.30 mode,
because it could not
detect a CM in response
to ANSam (ANSam
timeout).
The terminal could not detect ANSam.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
0-76
The calling terminal fell
back to T.30 mode,
because it could not
detect a JM in response
to a CM
(CM timeout).
The called terminal could not detect a CM due
to noise, etc.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
0-77 The called terminal fell The calling terminal could not detect a JM due
To Next Page
Loading...
Need help?
General