Copy Image Adjustments: Printing/Scanning
SM 4-133 D062/D063/D065/D066
Replacement
and
Adjustment
4.14 COPY IMAGE ADJUSTMENTS:
PRINTING/SCANNING
These adjustments must be performed after replacing any of the following parts:
Scanner wires
Lens block
Scanner motor
Polygon motor
Tandem tray side fences
Memory All Clear
4.14.1 IMAGE ADJUSTMENTS: PRINTING
Preparation
1. Make sure paper is installed correctly in each paper tray before you start these
adjustments.
2. Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for the
following procedures.
3. After completing these printing adjustments, be sure to set SP 2-902-3 to 0 again.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration, and adjust it using SP1-001.
Specification: 3 ± 2mm.
2. Check side-to-side registration for each paper feed station, and adjust with the
following SP modes.
To Next Page
Loading...
Need help?
General