Updating the Firmware
SM 5-19 D062/D063/D065/D066
System
Maintenance
procedure.
32
Data incorrect after download
interrupted
Do the recovery procedure for the module, then
repeat the installation procedure.
33 Incorrect SD card version
The ROM data on the SD card is not correct, or
data is damaged.
34
Module mismatch - Correct
module is not on the SD card
The data on the SD is not correct. Get the correct
data (Japan, Overseas, OEM, etc.) then install
again.
35
Module mismatch – Module on
SD card is not for this machine
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
36
Cannot write module – Cause
other than E34, E35
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
40
Engine module download
failed
Replace the data for the module on the SD card
and try again, or replace the BCU board.
42
Operation panel module
download failed
Replace the data for the module on the SD card
and try again, or replace the LCDC.
43
Stamp data module download
failed
Replace the data for the module on the SD card
and try again, or replace the hard disk.
44
Controller module download
failed
Replace the data for the module on the SD card
and tray again, or replace the controller board.
50
Electronic confirmation check
failed
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
Updating the LCDC for the Operation Panel
1. Use this procedure to update the LCDC (LCD Control Board).
2. Turn the copier main switch off.
3. Put the SD card into slot 2.
To Next Page
Loading...
Need help?
General