Resets
SM 5-7 D062/D063/D065/D066
System
Maintenance
4. Press Execute, then follow the prompts on the display to complete the procedure.
5. Make sure that you perform the following settings:
Execute SP2115 – Laser Beam Pitch Adjustment
Do the printer and scanner registration and magnification adjustments (See
"Replacement and Adjustment – Copy Image Adjustments: Printing/Scanning").
Do the touch screen calibration (See "Replacement and Adjustment – Touch
Screen Calibration").
Referring to the SMC data lists, re-enter any values, which had been changed
from their factory settings.
Execute SP3001-002 – ID Sensor Initial Setting
Make sure that SP 5112 is set to 'enabled', or the user will not be able to use
non-standard paper sizes.
Set SP 1902 001 (amount of fusing unit web used so far) to the most recent setting
(see the SMC list).
6. Check the copy quality and the paper path, and do any necessary adjustments.
5.2.2 SOFTWARE AND SETTING RESET
Software Reset
The software can be rebooted when the machine hangs up. Do one of these two steps.
Turn the main power switch off and on.
-or-
Push and hold down
together for over 10 seconds. When the machine beeps once,
release both buttons. After "Now loading. Please wait" is displayed for a few seconds, the
copy window will open. The machine is ready for operation.
Resetting the System
The system settings in the UP mode can be reset to their defaults with this procedure.
1. Make sure that the machine is in the copier standby mode.
2. Press the User Tools key.
3. Hold down the "#" key and touch the "System Setting" key.
4. A confirmation message will be displayed, then press "Yes".
Resetting Copy/Document Server Features Only
The copy/document server settings in the UP mode can be reset to their defaults with this
procedure.
1. Make sure that the machine is in the copier standby mode.
2. Push the User Tools key.
To Next Page
Loading...
Need help?
General