Bit Switches - 2
D418 92 SM
Printer Switch 00 (SP No. 1-103-001)
No Function Comments
1: Enabled 1: The machine prints the received and printed
date and time at the bottom of each received
page.
3-7 Not used Do not change the settings.
Printer Switch 01 (SP No. 1-103-002)
No Function Comments
0-2 Not used Do not change the settings.
Maximum print width used in the
setup protocol
Bit 4 Bit 3 Setting
0 0 Not used
0 1 A3
1 0 B4
3-4
1 1 A4
These bits are only effective when bit 7 of
printer switch 01 is "1".
5-6 Not used Do not change the settings.
7
Received message width
restriction in the protocol signal
to the sender
0: Disabled
1: Enabled
0: The machine informs the transmitting
machine of the print width depending on the
paper size available from the paper feed
stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the
setup protocol (NSF/DIS).
1: The machine informs the transmitting
machine of the fixed paper width which is
specified by bits 3 and 4 above.
To Next Page
Loading...
Need help?
General