Service Program Mode Tables
SM Appendix 4-15 D062/D063/D065/D066
Appendix:
Service
Program
Mode Tables
copying.
[–20 to +10/0/1]
2111 FCI Shade Detection
Allows shading detection if FCI (Fine Character Adjustment) smoothing is on.
With this SP switched on, photos and painted areas are detected, and FCI is not
applied in these areas. FCI is used for outputs in printer mode.
001 Matrix Size (>600 dpi)
[0 to 128/18/1]
002 Threshold Value (>600 dpi)
[0 to 128/4/1]
003 Matrix Size (<400 dpi)
[0 to 128/18/1]
004 Threshold Value (<400 dpi)
[0 to 128/4/1]
2114* Binary Edge Processing Parameter
Allows setting a parameter for binary edge processing for the printer application
with FCI switched off. The value for this SP is enabled only when the printer is
initialized. In all other cases, the data registered in the software are enabled.
This SP allows adjustment of image quality if the desired effect cannot be
achieved with the default settings for edge processing. However, some settings
could cause defective images on white paper.
001 Leading Edge Pixel Level (1200 dpi)
[2 to 15/7/1]
002 Trailing Edge Pixel Level (1200 dpi)
[2 to 15/14/1]
003 Continuous Pixel Level (1200 dpi)
[2 to 15/15/1]
004 Independent Dot Pixel Level (1200 dpi)
[2 to 15/15/1]
005 Leading Edge Pixel Level (600 dpi)
[2 to 15/7/1]
006 Trailing Edge Pixel Level (600 dpi)
007 Continuous Pixel Level (600 dpi)
008 Independent Dot Pixel Level (600 dpi)
[2 to 15/15/1]
To Next Page
Loading...
Need help?
General