EasyManua.ls Logo

Ricoh AFICIO MP C305SP - Sending Originals Using the Exposure Glass (Memory Transmission)

Ricoh AFICIO MP C305SP
773 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Make sure [Immed. TX] is not highlighted.
4. Place the original into the ADF.
5. Configure the scan and transmission settings in "Send Settings".
6. Specify a destination.
You can enter the destination's number or address directly or select from the Address Book by
pressing the destination key.
If you make a mistake, press the [Clear] key, and then enter again.
7. When sending the same original to several destinations (broadcasting), specify the next
destination.
8. If you send documents to Internet Fax or e-mail destinations or enable the "Email TX
Results" function, specify a sender.
9. Press the [Start] key.
Sending Originals Using the Exposure Glass (Memory Transmission)
1. Make sure [Immed. TX] is not highlighted.
2. Place the first page of the original face down on the exposure glass.
3. Specify a destination.
4. Make the scan settings you require.
5. Press the [Start] key.
6. Place the next original on the exposure glass within 60 seconds when you send multiple
originals, and then repeat steps 4 and 5.
Repeat this step for each page.
4. Fax
76

Table of Contents

Other manuals for Ricoh AFICIO MP C305SP

Related product manuals