Enabling and Disabling Protocols
Specify whether to enable or disable the function for each protocol. By making this setting, you can
specify which protocols are available and so prevent unauthorized access over the network. Network
settings can be specified on the control panel, or using Web Image Monitor, telnet,
SmartDeviceMonitor for Admin or Remote Communication Gate S. If you use SmartDeviceMonitor for
Admin, start Web Image Monitor from SmartDeviceMonitor for Admin and configure the settings from
there.
Protocol Port Setting method When disabled
IPv4 -
• Control panel
• Web Image Monitor
•
telnet
• SmartDeviceMonitor
for Admin
• Remote
Communication Gate S
All applications that
operate over IPv4
cannot be used.
IPv4 cannot be
disabled from Web
Image Monitor when
using IPv4 transmission.
IPv6 -
• Control panel
• Web Image Monitor
•
telnet
• SmartDeviceMonitor
for Admin
• Remote
Communication Gate S
All applications that
operate over IPv6
cannot be used.
IPsec -
• Control panel
• Web Image Monitor
• telnet
• SmartDeviceMonitor
for Admin
Encrypted transmission
using IPsec is disabled.
5. Enhanced Network Security
114
To Next Page
Loading...
Need help?
General
