Specifying the Device Option
With the following options, you can print with specific printer functions.
This manual covers all models, and therefore contains functions and settings that may not be available
for your model.
Configuring the Device Option
• The optional character strings the printer can recognize contain a maximum of 512 bytes.
• The number of available characters used as options is limited, depending on operating systems.
The configuration of the print option varies, depending on printing commands.
•
rsh
% rsh host_name print option1=value1,... < file_name
• rcp
% rcp file_name host_name:option1=value1,...
• ftp
ftp> put file_name option1=value1,...
"host_name" is the printer host name. "file_name" is the file name you want to print.
The device option is specified in the form of "option=value". For details about types of device options
and values, see the following explanations.
For example, the following settings are for printing with rsh, rcp, and ftp : switch to PostScript, feed
paper from paper feed tray 1, set the printing amount to 3 sets, and print with the resolution set to 600
dpi (host_name :nphost, file_name :file1).
• rsh
% rsh nphost print filetype=postscript,tray=tray1,copies=3,resolution=600 <
file1
• rcp
% rcp file1 nphost:filetype=postscript,tray=tray1,copies=3,resolution=600
• ftp
ftp> put file1 filetype=postscript,tray=tray1,copies=3,resolution=600
• Multiple options must be separated by commas (,). Do not use spaces.
• When the printing file contains the PostScript commands that control the options, the command
takes priority.
1. UNIX Configuration
22
To Next Page
Loading...
Need help?
General
