2. Getting Started
This chapter describes how to start using this machine.
Guide to Names and Functions of Components
Guide to Components (mainly Europe)
• Do not obstruct the ventilation holes by placing objects near them or leaning things against them. If
the machine overheats, a fault might occur.
Front and right view
1. Exposure glass cover or ADF
(The illustration shows the ADF.)
Lower the exposure glass cover or the ADF over originals placed on the exposure glass.
If you load a stack of originals in the ADF, the ADF will automatically feed the originals one by one.
2. Exposure glass
Place originals face down here.
3. Control panel
See p.36 "Guide to the Names and Functions of the Machine's Control Panel".
4. Front cover
Open to access the inside of the machine.
25
To Next Page
Loading...
Need help?
General
