Message Status
"Offline" The machine is offline.
"Please wait." This message might appear for a second or two while the machine is
preparing, performing initial adjustments, or adding toner. Wait a
while.
"Printing..." The machine is printing. Wait a while.
"Ready" This is the default ready message. The machine is ready for use. No
action is required.
"Resetting job..." The machine is resetting the print job. Wait until "Ready" appears on
the display panel.
"Setting change..." The machine is changing settings. You cannot use the control panel
while this message is displayed. Wait a while.
"Waitg. for prt.data" The machine is waiting for the next data to print. Wait a while.
"Job suspended." Printing was temporarily suspended because [Job Operation] or the
[Stop] key was pressed.
"Updating certif..." The @Remote certificate is being updated. Wait a while.
Messages displayed on the control panel when using the printer function
• Before turning the main power switch off, see p.49 "Turning On/Off the Power".
Message Causes Solutions
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
•
The settings are not
updated although the
unit is detected.
Turn off the main power switch, and
then confirm the wireless LAN board is
inserted correctly. And then, turn on the
main power switch again. If the
message appears again, contact your
service representative.
When Messages Are Displayed on the Control Panel
173
To Next Page
Loading...
Need help?
General
