Function Level 0 Level 1 FIPS 140 Level 2
SSDP Active Active Inactive Inactive
SMB Active Active Inactive Inactive
NetBIOS over TCP/IPv4 Active Active Inactive Inactive
WSD (Device) Active Active Active Active
WSD (Printer) Active Active Active Active
WSD (Scanner) Active Active Active Active
WSD (Encrypted Communication of
Device)
Inactive Inactive Active Active
RHPP Active Active Inactive Inactive
The same settings are applied to IPv4 and IPv6.
TCP/IP setting is not governed by the security level. Manually specify whether to activate or
inactivate this setting.
NetWare
Function Level 0 Level 1 FIPS 140 Level 2
NetWare Active Active Inactive Inactive
If NetWare is not used on your network, the above settings are not applicable.
SNMP
Function Level 0 Level 1 FIPS 140 Level 2
SNMP Active Active Active Active
Permit Settings by SNMPv1 and v2 On Off Off Off
SNMPv1,v2 Function Active Active Inactive Inactive
SNMPv3 Function Active Active Active Active
Permit SNMPv3 Communication
Encryption/
Cleartext
Encryption/
Cleartext
Encryption
Only
Encryption
Only
Specifying Network Security Level
125
To Next Page
Loading...
Need help?
General
