Setting Description Setting value
Remote Address
Specify the address of the
IPsec transmission partner.
You can also specify an
address range.
The IPsec transmission
partner's IPv4 or IPv6 address.
If you are not setting an
address range, enter 32 after
an IPv4 address, or enter 128
after an IPv6 address.
Security Policy Specify how IPsec is handled.
• Apply
•
Bypass
•
Discard
Encapsulation Mode
Specify the encapsulation
mode.
(auto setting)
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
Select the transport mode (this
has no bearing on the security
level).
If you specify "Tunnel", you
must then specify the "Tunnel
End Point", which are the
beginning and ending IP
addresses. Set the same
address for the beginning
point as you set in "Local
Address".
IPsec Requirement Level
Specify whether to only
transmit using IPsec, or to
allow cleartext transmission
when IPsec cannot be
established.
(auto setting)
• Use When Possible
• Always Require
5. Enhanced Network Security
150
To Next Page
Loading...
Need help?
General
