4. Select [Active] for each function: "Collect Job Logs", "Collect Access Logs" and "Collect
Eco-friendly Logs".
5. Specify the collection level for each function, "Job Log Collect Level", "Access Log Collect
Level", and "Eco-friendly Log Collect Level".
When a level is changed, the selection status of log details changes according to the level.
To change individual items of the log details, configure the setting for each item. If the collection
level selected is [Level 1] or [Level 2], once individual items of the log details are changed, the
level changes to [User Settings].
6. Click [OK].
7. "Updating..." appears. Wait for about one or two minutes, and then click [OK].
If the previous screen does not reappear after you click [OK], click the web browser's [Reload]
button.
8. Log out.
• The greater "Access Log Collect Level" setting value, the more logs are collected.
Disabling log transfer to the log collection server
Use the following procedure to disable log transfer to the log collection server. Note that you can
change the log transfer setting to [Inactive] only if it is already set to [Active].
1. Log in as the machine administrator from Web Image Monitor.
2. Point to [Device Management], and then click [Configuration].
3. Click [Logs] under "Device Settings".
4. Select [Inactive] under "Transfer Logs".
5. Click [OK].
6. Log out.
Specifying log encryption
Use the following procedure to enable/disable log encryption.
1. Log in as the machine administrator from Web Image Monitor.
2. Point to [Device Management], and then click [Configuration].
3. Click [Logs] under "Device Settings".
4. Select [Active] under "Encrypt Logs".
To disable log encryption, select [Inactive].
7. Managing the Machine
206
To Next Page
Loading...
Need help?
General
