Machine information in the work area is not automatically updated. Click [Refresh] at the upper right in the work
area to update the machine information. Click the Web browser's [Refresh] button to refresh the entire browser
screen.
• When using a host name under Windows Server 2003/2003 R2/2008/2008 R2 with IPv6
protocol, perform host name resolution using an external DNS server. The host file cannot be used.
When User Authentication is Set
Login (using Web Image Monitor)
Follow the procedure below to log in when user authentication is set.
1. Click [Login].
2. Enter a login user name and password, and then click [Login].
For details about the login user name and password, consult your network administrator.
Depending on the configuration of your Web browser, the login user name and password might be
saved. If you do not want to save them, configure your Web browser's settings so that this information
is not saved.
• For user code authentication, enter a user code in [Login User Name], and then click [Login].
• The procedure may differ depending on the Web browser used.
Log out (using Web Image Monitor)
Click [Logout] to log out.
• When you log in and make the setting, always click [Logout].
About Menu and Mode
There are two modes available with Web Image Monitor: guest mode and administrator mode.
Displayed Items may differ depending on the machine type.
Guest Mode
In the guest mode, machine status, settings, and print job status can be viewed, but the machine settings
cannot be changed.
4. Monitoring and Configuring the Machine
114
To Next Page
Loading...
