Ricoh aficio MP W3601 - Enhanced Network Security; Preventing Unauthorized Access; Access Control

NBT (NetBIOS over TCP/IP) scope ID selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "ScopeID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
wsmfp
Use the "wsmfp" command to view and configure the WSD (Device) and WSD (Printer).
View settings
msh> wsmfp
Comment settings
msh> wsmfp comments "comment"
• If you do not specify a comment, current setting is displayed.
Location configuration
mah> wsmfp location "location"
• If you do not specify a comment, current setting is displayed.
Presentation URL configuration
msh> wsmfp url "URL"
• Enter the URL string in the "URL".
WSD (Device) TCP port configuration
msh> wsmfp devport "port_number"
• The Default is 53000.
WSD (Printer) TCP port configuration
msh> wsmfp prnport "port_number"
• The Default is 53001.
WSD (Printer) timeout configuration
msh> wsmfp prntimeout [30-65535]
Remote Maintenance Using telnet
169
4