Connecting to the Ethernet Interface
This section describes how to connect an Ethernet cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1. Make a loop 3 cm (1.2 inch) (1) from the end of the Ethernet cable and attach the included
ferrite core to the loops as shown.
2. Make sure the main power is switched off.
3. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
4. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
2. Connecting the Machine
66
To Next Page
Loading...
