Resetting URL names registered as link destinations
msh> web "ID" clear name
Specify "1" or "2" for ID as the number corresponding to the link name.
Help URL configuration
You can set URLs linked by clicking "?" on Web Image Monitor.
msh> web help http://"Help URL or IP address"/help/
Resetting Help URL
msh> web clear help
wiconfig
Use the "wiconfig" command to make settings for IEEE 802.11.
View settings
msh> wiconfig
View IEEE 802.11 information
msh> wiconfig cardinfo
If IEEE 802.11 is disabled or unavailable, information about it will not appear.
Configuration
msh> wiconfig "parameter"
Parameter Value configured
mode {ap|802.11adhoc} You can set the infrastructure mode (ap) or the
802.11 Ad hoc mode (802.11adhoc).
The default is the infrastructure mode.
ssid "ID value" You can specify an SSID in infrastructure mode.
The characters you can enter in the SSID string
are ASCII 0x20-0x7e (32 bytes). If you do not
specify a character string, the machine will
connect to the nearest access point.
The default SSID is blank.
Remote Maintenance Using telnet
163
To Next Page
Loading...
