Parameter Value configured
miccheck {on|off} You can enable or disable the MIC check
function.
The default setting is "On" (enabled).
If you specify "Off", you cannot perform MIC
checks. We recommend you specify "On" for the
MIC check function when using this machine.
• p.35 "Wireless LAN"
wins
Use the "wins" command to configure the WINS server settings.
Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address
is the valid address.
Configuration
msh> wins "interface_name" {on|off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure the primary WINS server IP address.
• Use the "secondary" command to configure the secondary WINS server IP address.
• Do not use "255.255.255.255" as the IP address.
4. Monitoring and Configuring the Machine
168
To Next Page
Loading...
