Tray Paper Settings
This section describes the user tools in the Tray Paper Settings menu under System Settings.
• If the specified paper size differs from the actual size of the paper loaded in the paper tray, a misfeed
might occur because the correct paper size was not detected.
Paper Tray Priority: Copier (copier/Document Server)
Specify the tray to supply paper for output.
Default: [Tray 1]
When optional cut paper tray is installed, the default setting will be the cut paper tray.
When optional paper roll tray or optional cut paper tray is installed, [Tray 2] is displayed.
When optional two paper rolls tray and cut paper tray are installed, [Tray 3] is displayed.
Paper Tray Priority: Printer
Specify the tray to supply paper for output.
Default: [Tray 1]
When optional paper roll tray or optional cut paper tray is installed, [Tray 2] is displayed.
When optional two paper rolls tray and cut paper tray are installed, [Tray 3] is displayed.
Tray Paper Size: Tray 1
Select the size of the paper loaded in the paper tray.
• A Series:
A0 Width (841 mm), A1 Width (594 mm), A2 Width (420 mm), A3 Width (297 mm), A4 Width
(210 mm)
• JIS B Series:
B1 JIS Width (728 mm), B2 JIS Width (515 mm), B3 JIS Width (364 mm), B4 JIS Width (257
mm)
• Others:
880 mm, 800 mm, 707 mm, 680mm, 660 mm, 625mm, 620mm, 490mm, 440 mm
• Engineering:
34 inch, 22 inch, 17 inch, 11 inch, 8
1
/
2
inch
• Architecture:
36 inch / 914 mm, 24 inch, 18 inch, 12 inch, 9 inch
• Others:
30 inch
Default:
1. System Settings
24
To Next Page
Loading...
