• p.17 "Accessing User Tools"
• p.273 "Configuring IEEE 802.1X"
Wireless LAN
This section describes the user tools in the Wireless LAN menu under Interface Settings.
[Wireless LAN] is displayed when this machine is installed with the wireless LAN interface board.
Be sure to make all settings simultaneously.
Communication Mode
Specifies the communication mode of the wireless LAN.
Default: [Infrastructure Mode]
SSID Setting
Specifies SSID to distinguish the access point in [Infrastructure Mode] or [802.11 Ad-hoc Mode].
The characters that can be used are ASCII 0x20-0x7e (32 bytes).
If blank is specified in [802.11 Ad-hoc Mode], "ASSID" appears.
Ad-hoc Channel
Specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the channel that
matches the type of wireless LAN being used. The channel in use might differ depending on the country.
The following channels are available:
(mainly Europe and Asia)
• IEEE 802.11 a/b/g Wireless LAN
Frequency range:
2412 - 2472 MHz (1 - 13 channels)
5180 - 5240 MHz (36, 40, 44 and 48 channels)
In some countries, only the following channels are available:
• IEEE 802.11 b/g Wireless LAN
Frequency range:
2412 - 2462 MHz (1 - 11 channels)
Default: [11]
(mainly North America)
• IEEE 802.11 a/b/g Wireless LAN
Frequency range:
2412 - 2462 MHz (1 - 11 channels)
Interface Settings
35
To Next Page
Loading...
