2. Connecting the Machine
This chapter describes how to connect the machine to the network and specify the network settings.
Connecting to the Interface
This section explains how to identify the machine's interface and connect the machine according to the
network environment.
• A network interface cable with a ferrite core must be used for RF interference suppression.
1. Gigabit Ethernet port (optional)
Port for using the 1000BASE-T, 100BASE-TX, or 10BASE-T cable
2. USB Host Interface
Port for connecting the USB interface cable
Use this interface to connect the machine to a card authentication device or memory card reader.
3. 10BASE-T/100BASE-TX port
Port for connecting the 10BASE-T or 100BASE-TX cable
4. USB2.0 port
Port for connecting the USB2.0 interface cable.
5. Wireless LAN interface unit (optional)
This unit allows you to connect the machine to an IEEE 802.11 a or IEEE 802.11 b/g wireless LAN.
• The Ethernet and Gigabit Ethernet port cannot be used simultaneously. If the optional Gigabit Ethernet
board is installed, connect the Ethernet cable to the port on the Gigabit Ethernet board Communication
with the machine will fail if cables are connected to both ports simultaneously.
65
To Next Page
Loading...
