Programming the LDAP server
This section describes how to specify the LDAP server settings.
This function supports LDAP version 2.0 and 3.0.
Program the LDAP server to find e-mail destinations in the LDAP server Address Book directly.
This function is possible when sending scan files by e-mail using the scanner function.
To start an LDAP search, make sure that the items listed below are set. For other items, check your
environment and make any necessary changes.
• Server Name
• Search Base
• Port Number
• Authentication
• Search Conditions
If [Kerberos Authentication] is selected be sure to set the "User Name", "Password", and the "Realm Name".
If [Digest Authentication] or [Cleartext Authentication] is selected be sure to set the "User Name" and
"Password".
To use the LDAP server in Administrator Tools, select [On] under "LDAP Search".
The LDAP version 2.0 does not support Digest Authentication.
To select Kerberos Authentication, a realm must be registered in advance.
Programming the LDAP server
This section describes how to program the LDAP server.
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [ Next] twice.
5. Press [Program / Change / Delete LDAP Server].
6. Check that [Program / Change] is selected.
7. Select the LDAP server you want to program or change.
When programming the server, select [*Not Programmed].
8. Press [Change] under "Name".
9. Enter the name, and then press [OK].
10. Press [Change] under "Server Name".
1. System Settings
56
To Next Page
Loading...
