ipsec
Use the "ipsec" command to view and configure the IPsec settings.
View settings
The following command displays the current IPsec settings:
msh> ipsec
• For details about displayed contents, consult your administrator.
ipv6
Use the "ipv6" command to display and configure the IPv6 settings.
View Setting
msh> ipv6
IPv6 stateless address
msh> ipv6 stateless {on|off}
If "on" is selected, IPv6 requests information required for maintaining stateful connection to the router
for as long as the printer power is turned on. This setting allows information from the router to be
obtained constantly, and periodically refreshes the effective period of the stateless address.
logout
Use "logout" command to quit telnet.
Quit telnet
msh> logout
A confirmation message appears.
{yes|no|return}
Enter [yes], [no] or [return] by typing the word, and then press the [Enter] key.
To save the changes and quit telnet, enter [yes].
To discard the changes and quit telnet, enter [no].
To continue making changes, enter [return]
lpr
Use the "lpr" command to view and configure the LPR settings.
4. Monitoring and Configuring the Machine
146
To Next Page
Loading...
